This way you can clean the kitchen extractor and leave it like new

This way you can clean the kitchen extractor and leave it like new

Learn the best tricks to clean the kitchen extractor hood quickly and easily.

He kitchen extractor It is a fundamental element and is given very low priority in the cleaning. It is one of the areas where the most dirt accumulates. Inside it is similar to the dirt that is generated in the oven and the racks when they are filled with grease. Keeping it clean will not only improve its performance but extend its useful life also.

It is a part that usually forget when cleaning as it seems very difficult. But the reality is that there are certain home tricks that make this task much easier and can be done more often. These are the best tricks to clean the kitchen extractor hood safely. quick and simple.

extractor

How to clean the kitchen extractor

Remove the fat from inside

Cleaning the inside of the extractor is as complicated as it is necessary since It helps a lot for its correct functioning. To remove the fat, it is best to use stainless steel degreaserso as not to damage the bell, in this way:

  1. Remove the filters
  2. Put a good coat of degreaser inside.
  3. Let it act for a few minutes
  4. Wipe the area with a cloth or scrubber
  5. Repeat the process until it is completely clean.

kitchen gas

Pexels

Sodium bicarbonate

To clean the inside of the extractor, including inside the motor, the sodium bicarbonate it’s key. It should be done as follows:

  1. Heat the baking soda in a couple of pots with water
  2. Once the water starts to boil, turn on the extractor.
  3. Let the steam rise and get inside the device to clean it
  4. Leave like this for an hour
  5. As it empties, add more water and baking soda.
  6. The grease will begin to fall from the hoods.
  7. After an hour, turn off the heat and protect it with absorbent paper so that it does not get stained with grease.
  8. Clean the extractor with a cloth or a brush containing a mixture of baking soda and water for some areas.
  9. Finish cleaning with a final wipe with a clean cloth.

Clean the filters

Filters can be put in the dishwasher either soak with water and degreaser for a few minutes. After wipe by the fat, which will have become soft and, in the most complicated areas, use a toothbrush.

Source: Ambito

Leave a Reply

Your email address will not be published. Required fields are marked *

Latest Posts